是否在网络接口启动时运行/etc/network/if-up.d中的所有脚本？
如果是这样,interfaces文件中的post-up命令是什么？
解决方法
是的,通常会运行任何标记为可执行文件并放在该文件夹中的脚本.由于使用了运行部件,因此文件仅限于一组特定的名称.
post-up与up up相同.将脚本放在if-up.d中就像使用指向其他地方的脚本或命令的post-up一样.通常,当您只需要为单个界面运行单个命令时,您将使用up | post-up.当你有更复杂的东西时,你会创建一个脚本.
男人接口
...
up command
post-up command
Run command after bringing the interface up. If this command
fails then ifup aborts,refraining from marking the interface as
configured (even though it has really been configured),prints
an error message,and exits with status 0. This behavior may
change in the future.
...
There exists for each of the above mentioned options a directory
/etc/network/if-<option>.d/ the scripts in which are run (with no argu-
ments) using run-parts(8) after the option itself has been processed.
男子跑步部位
run-parts runs all the executable files named within constraints described below,If the --lsbsysinit option is not given then the names must consist entirely of upper and lower case letters,digits,underscores,and hyphens. ... Files are run in the lexical sort order of their names unless the --reverse option is given,in which case they are run in the opposite order.
