CentOS之——Bringing up interface eth0: Determining if ip address 192.168.1.81 is already in use for de

前端之家收集整理的这篇文章主要介绍了CentOS之——Bringing up interface eth0: Determining if ip address 192.168.1.81 is already in use for de前端之家小编觉得挺不错的,现在分享给大家,也给大家做个参考。

转载请注明出处:http://blog.csdn.net/l1028386804/article/details/78253013

重启网卡出现提示

Bringing up interface eth0:  Determining if ip address 192.168.1.81 is already in use for device eth0...
                                                           [  OK  ]
Bringing up interface eth1:  Determining if ip address 192.168.1.83 is already in use for device eth1...
                                                           [  OK  ]
该警告一般是由于网卡解析arp协议导致的,可在网卡的配置文件中加入ARPCHECK=no参数来屏蔽该检查
[root@liuyazhuang ~]# cat /etc/sysconfig/network-scripts/ifcfg-eth0
TYPE=Ethernet
BOOTPROTO=none
IPADDR=192.168.1.81
PREFIX=24
GATEWAY=192.168.1.254
DEFROUTE=yes
IPV4_FAILURE_FATAL=yes
IPV6INIT=no
NAME=eth0
UUID=86d44060-4579-48cc-b85b-219a206ca37c
ONBOOT=yes
HWADDR=00:50:56:95:09:76
LAST_CONNECT=1411004329
ARPCHECK=no
再次启动网卡,一切正常
[root@liuyazhuang ~]# service network restart
Shutting down interface eth0:                              [  OK  ]
Shutting down interface eth1:                              [  OK  ]
Shutting down loopback interface:                          [  OK  ]
Bringing up loopback interface:                            [  OK  ]
Bringing up interface eth0:                                [  OK  ]
Bringing up interface eth1:                                [  OK  ]

猜你在找的CentOS相关文章