我在72gB硬盘上安装了Windows Server,现在我正尝试用全新安装的CentOS 7 x64覆盖它.
当我尝试安装它时,它说我需要手动配置硬盘,但是当我打开分区工具时,没有检测到硬盘.
我正在使用~4GB DVD安装程序.
我该如何解决这个问题？
因此,从2001年到2009年左右的HP RAID控制器驱动程序是CCISS driver.有a transition to the HPSA driver at some point,将Smart Array控制器支持转移到常规SCSI子系统而不是专用块驱动程序……
从G1到G5时代的惠普服务器使用了CCISS驱动程序.在较新的操作系统(EL6和转发)上,HP ProLiant G6和更新的系统使用了HPSA驱动程序.
It turns out that RHEL7 removes the old CCISS module.在这种情况下,由于无法识别G5服务器中的Smart Array P400控制器,您的修复是强制HPSA驱动程序加载旧控制器.这样做：
hpsa.hpsa_allow_any=1
作为模块参数……
从man page开始.
hpsa_allow_any=1: This option allows the driver to attempt to operate
on any HP Smart Array hardware RAID controller,even if it is not
explicitly known to the driver. This allows newer hardware to work
with older drivers. Typically this is used to allow installation of
operating systems from media that predates the RAID controller,
though it may also be used to enable hpsa to drive older controllers
that would normally be handled by the cciss(4) driver. These older
boards have not been tested and are not supported with hpsa,and
cciss(4) should still be used for these.
编辑
这是一个比预期更为复杂的过程.你需要add that string to the module load parameters.
官方的说法是不再支持旧的控制器.虽然你可以让它运行,但它并不理想.所以我现在可能会远离EL7.可能会有一个解决方法,因为这些服务器的现有安装基础……
kernel component,BZ#1061210 When the hpsa_allow_any option is used,
the hpsa driver allows the use of PCI IDs that are not listed in the
driver’s pci-id table. Thus,cards detected when this option is used,
are not supported in RedHat EnterpriseLinux 7.
kernel component,BZ#975791
The following cciss controllers are no longer supported:
◦ Smart Array 5300
◦ Smart Array 5i
◦ Smart Array 532
◦ Smart Array 5312
◦ Smart Array 641
◦ Smart Array 642
◦ Smart Array 6400
◦ Smart Array 6400 EM
◦ Smart Array 6i
◦ Smart Array P600
◦ Smart Array P800
◦ Smart Array P400
◦ Smart Array P400i
◦ Smart Array E200i
◦ Smart Array E200
◦ Smart Array E500
◦ Smart Array P700M
