在QEMU,我的代码效果很好：

.h文件

#define COM1_PORT (0x03F8)
#define UART_PORT (COM1_PORT)

enum uart_port_offs_t
{   //          DLAB RW
    THR = 0,//   0   W  Transmitter Holding Buffer
    RBR = 0,//   0  R   Receiver Buffer
    DLL = 0,//   1  RW  Divisor Latch Low Byte
    IER = 1,//   0  RW  Interrupt Enable Register
    DLH = 1,//   1  RW  Divisor Latch High Byte
    IIR = 2,//   -  R   Interrupt Identification Register
    FCR = 2,//   -  RW  FIFO Control Register
    LCR = 3,//   -  RW  Line Control Register
    MCR = 4,//   -  RW  Modem Control Register
    LSR = 5,//   -  R   Line Status Register
    MSR = 6,//   -  R   Modem Status Register
    SR  = 7,//   -  RW  Scratch Register
};

.c文件

void uart_init(void)
{
    outb(UART_PORT + IER,0x00); // Disable all interrupts

    outb(UART_PORT + LCR,LCR_DLAB);
    outb(UART_PORT + DLL,BAUD_LL); // Set divisor (lo byte)
    outb(UART_PORT + DLH,BAUD_HL); //             (hi byte)
    outb(UART_PORT + LCR,LCR_WORD_BITS_8 | LCR_PAR_NONE | LCR_STOP_BITS_1);
    outb(UART_PORT + FCR,FCR_ENABLE | FCR_CLR_RECV | FCR_CLR_SEND | FCR_TRIGGER_16);
    outb(UART_PORT + MCR,MCR_DSR | MCR_RTS | MCR_AUX2);
}

ssize_t uart_write(const char *buf,size_t len)
{
    size_t written = 0;
    while (written < len) {
        while (!is_output_empty()) {
            asm volatile ("pause");
        }
        outb(UART_PORT + THR,buf[written]);
        ++written;
    }
    return written;
}

主要

SystemTable->ConOut->OutputString(SystemTable->ConOut,L"Exiting EFI boot services ...\r\n");
SystemTable->BootServices->ExitBootServices(ImageHandle,map_key);

uart_init();

while (1) {
    const char s[] = "UART\r\n";
    uart_write(s,sizeof (s) - 1);
}

这些规格对我没什么帮助.我猜英特尔Galileo板上的UART不使用/模拟普通/传统COM端口3F8h,2F8h,3E8h或2E8h.

谁能告诉我我做错了什么,甚至发布了一个最小的裸机世界示例？